LS ELECTRIC H100 0008-2(PLUS), Manual

Page: 85 / 239

Perform Basic Operations
59
3.2.2 Operation Modes
The inverter is operable only when it is in HAND or AUTO mode. HAND mode is for local
control using the keypad, while AUTO mode is for remote control via communication. On
the other hand, the inverter stops operating when it is in OFF mode. Select one of the
modes (HAND / AUTO / OFF) to operate the inverter or stop the operation.
Follow the examples below to learn how to switch between operation modes.
Operating the Inverter in HAND mode
1 Turn on the inverter. The inverter enters OFF mode and the OFF LED turns on.
2 Move to Parameter mode and set DRV-07 (frequency reference)
to ‘0 (keypad)’.
3 Press the [HAND] key to enter HAND mode (local control mode). HAND mode LED
turns on (the OFF LED turns off) and the inverter begins to operate.
4 Press the [OFF] key to stop the inverter operation. The inverter stops operating and the
OFF LED turns on.
Operating the inverter in AUTO Mode
1 In OFF mode (when the OFF LED is on), move to Parameter mode and configure the
command source at DRV-07 (frequency reference source).
2 Press the [AUTO] key to enter AUTO mode. In AUTO mode, the inverter operates
based on the input from the command source set at DRV-07. For example, if DRV-07
(frequency reference
source) is set to ‘0 (Keypad)’, the frequency reference is set, and
the run command is set to
‘ON’, the inverter starts operating as soon as the [AUTO] key
on the keypad is pressed.
3 Press the [Auto] key again to stop the inverter operation using the keypad. In AUTO
mode, the inverter begins or stops operating when the [AUTO] key is pressed.