Long Range Systems
4
TX-14C User Manual
TX-14C Keypad Functions
Before you begin using the TX-14C handheld transmitter, read the following keypad descriptions.
Functions Keys
Clears the table from the Host Receiver list.
To designate a table as seated, enter the table number and press SEAT
Lists the table as ready on the Host Receiver.
To mark a table as Open and ready to be Seated, enter the table num-
ber and press OPEN
Sends the hold command to the Host Receiver.
To mark a table as Closed, enter the table number and press CLOSE
Transfers a party from one table to another
To move a party from one table to another, enter the table number
you wish to transfer from, press TRNSFR, enter the number of the
table you wish to transfer the party to, press ENTER (Table# -
Transfer - Table # - Enter).
Sends the Bus command to the Host receiver.
When a table is being bussed, enter the table number and press BUS
Clears the input to restart a new command
Checks functions of the TX-14C handheld: Version Check, Battery Level,
Handheld Reset, and Range Test,
Completes the Transfer function.
Number Number
The number keys (1 – 0) are used to enter table numbers.
Test and Reset Functions
Version Check
Press 5 then the TEST key to check the version.
Battery Check
Press the TEST key to check the battery. The display shows a number to indicate the battery charge (5 is
fully charged and 1 is very weak).
Reset
If the battery has been allowed to totally discharge, it may be necessary to reset the TX-14C for it to func-
tion properly. To reset the TX-14C:
1. Put the TX-14C on charge.
2. After the TX-14C is charged, enter 0-7-6 on the keypad.
3. Press the Test button.
Range Test
The operating range of the unit can be checked by sending continuous open and close commands to the re-
ceiver while moving around the test area. To start the test, press 1-2-3 TEST. To end the test press CLR
(Clear).
Lo
n
g
R
a
n
g
e
S
yste
m
s
4
T
14C
U
se
r M
a
n
u
a
l