Associating Table Genie
1. From the Setup menu select SYSTEM TOOLS.
2. Select WPAN.
3. Select Associate (the unit will stay in associate for 5 minutes and then associate
will have to be restarted.)
4. Install a battery in the Table Genie and press all 3 buttons after the unit begins to
flash. Then:
• The buttons will light back and forth.
• The buttons will flicker rapidly.
• The buttons will go out.
• The popup will ask for the entry of a table number.
5. Repeat steps 3 and 4 until all units are associated.
6. To exit, press EXIT on T7502.
Note:
If unit fails to join, remove battery, put unit aside, and repeat process after all
other units are joined.
Operation
1. When a button is pressed on the Table Genie, a table number will be displayed
and timer will start on the monitor.
2. The last pressed button on the Table Genie will blink until cleared.
3. To clear a unit, use the user defined cancel sequence (see user manual to change.)
4. When cleared, the button will stop flashing and the monitor will clear.
5. If the table monitor is not cleared
• Within a preset time, the color for that table will change to yellow.
• If the table is still not cleared after another preset time, the monitor for that table
will turn red and the manager will be paged.
• The manager will periodically be re-paged until the table is cleared.
Setup for Table Genie Operation
From the Setup menu select GLOBAL SETTINGS.
1. Select OPERATION MODE then Push For Service Monitor
2. Press ENTER.
3. Press EXIT.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause harmful interference.
Warning: Changes or modifications not expressly approved by Long Range Systems could void the user's
authority to operate the equipment.
Long Range Systems
2
Table Genie Quick Guide
XU-0058 091114
