USER MANUAL
|
RX-CS6, RX-CS7, & RX-AT9
LRSUS.COM | 5
TROUBLESHOOTING
Pager Shows an Error Code (CS7 and AT9 Only)
1. If code is E007, E008, or E009 try over-the-air (OTA) programming. See transmitter
manual for specific instructions on OTA programming a pager.
2. For all other codes, contact LRS for service.
Pager Does Not Receive Pages
1. Be sure that the pagers are charged.
2. Be sure transmitter power is plugged in and display is lit.
• If display is blank, check power supply as described below.
• If display is lit, check transmitter functions described in transmitter’s users manual.
3. Pagers will flash and may or may not vibrate depending on a preprogrammed
configuration when removed from the charger base plate.
Check The Power Supply
1. Be sure the wall outlet that the power supply is plugged into is working (plug anoth-
er device into it and see that it works properly).
2. Be sure the wire that plugs into the side of the transmitter is plugged in securely.
Charging Check
Please take note of the following charging requirements and functions.
1. A maximum of 15 pagers may be stacked on one charging base plate at a time.
2. If your system has more than 15 pagers and you only have one charging base plate,
call Long Range Systems to purchase additional.
3. If your system has 2 or more charging base plates, check that the jumper wires
between the base plates are connected securely.
4. Pagers on charge will flash a red LED light every 5 seconds, forming an upward mov-
ing red light on the pager stack.
5. A maximum of 2 charging base plates per power supply are allowed.
6. Check for dirty charging pins on your guest pagers. To clean, use a damp rag, and
wipe the 4 metal contacts on the front and back of each pager.
7. Be sure that all pagers are plugged in and charging when not in use. Even for long
periods of inactivity.
