LP Morgan Installation Instructions | 11
LP Morgan Rondo Opus Manual
Height adjustment - Standard Motorised screens
Setting the motor limits will adjust the viewing height of the screen.
To adjust the motor limits lift the front cover off the casing by snapping the
bottom edge away from the wall at each end. The motor limits are on the
right hand side (see below).
Bottom limit
adjustment screw with
yellow colour surround
Each turn of the limit screw corresponds to about 15mm of screen travel.
Clockwise rotation of the screw will set the screen higher. Anti-clockwise will
lower the position.
The screen needs to be plugged into the mains while adjusting the limits.
Be aware that some control products switch off power to the screen after the
limit has been reached.
The motor has a built in thermal overload device that will switch the motor off
after four minutes of continuous use. If this occurs, wait until the motor cools
(about 15-20 mins) before continuing.
Do not remove the sticker or adjust the other screw
(upper limit adjustment).
This can retreat the screen into the case, damaging the screen
and voiding your warranty.
Note:
White colour surround switch controls the upper limit and
yellow colour surround switch controls the bottom limit.