LOYTEC L-Proxy, User Manual

Page: 31 / 150

L-Proxy User Manual 31 LOYTEC
Version 3.1 LOYTEC electronics GmbH
If an L-Proxy uses automatic NAT router discovery and the NAT address is known
beforehand, the L-Proxy can simply be added to the channel in the L-IP configuration
server by specifying the NAT address and correct port. If the NAT address is not known,
take the following steps to add the L-Proxy to a CEA-852 IP channel in the configuration
server:
1. On the L-Proxy turn on automatic NAT router discovery (this is the default setting).
The NAT address should read ‘
Auto (no NAT)
’.
2. Enter the IP address of the configuration server in the CEA-852 device configuration
menu. Exit and save but do not reboot.
3. Go back to the main menu. Wait 15 seconds.
4. Go to the IP configuration menu. The NAT address should show the public IP address
of the NAT router or firewall (e.g., ‘
Auto (198.18.76.1)
’).
5. On the configuration server, add the L-Proxy to the configuration server using this IP
address.
4.7.12 Option b – Multicast Address
This menu option allows the user to add the CEA-852 device of the L-Proxy into a multi-
cast group for the CEA-852 IP channel. Enter the channel’s IP multi-cast address here.
Please contact your system administrator on how to obtain a valid multi-cast address. Refer
to the L-IP User Manual [1] to learn when it is beneficial to use multi-cast addresses in
your channel.
4.8 Reset configuration (load factory defaults)
This menu item allows resetting the device into its factory default state. The menu appears
as shown in Figure 20.
Reset Configuration Menu
========================
[1] Reset everything to factory defaults
[3] Reset all passwords
[4] Clear data point configuration
[q] Quit
Please choose:
Figure 20: Reset to Factory Defaults Menu
4.8.1 Option 1 – Reset everything to factory defaults
Select this menu item to reset the complete device to factory defaults (including error log,
configuration files, passwords etc.).
4.8.2 Option 3 – Reset all passwords
Select this menu item to reset all passwords (Web interface, FTP server etc.) to factory
defaults.
4.8.3 Option 4 – Clear data point configuration
Select this option to clear all configured data points, such as CEA-709 network variables or
user registers. This effectively clears the entire port configuration. The L-Proxy must be
rebooted to let the changes take effect.