L-DALI User Manual
79
LOYTEC
Version 5.2
LOYTEC electronics GmbH
sticker can be attached to a plan or list as part of the installation process to mark
the devices location in a convenient way.
Figure 75: DALI Installation: Device Assignment
After the devices have been assigned they are listed under
Devices in Database
in the upper
half of the Web interface (see Figure 75). The table displays the following information:
Name
: This column displays the name of the DALI device. Click on the name to
jump to the data point configuration page of the corresponding fieldbus object.
The name can be changed by editing the
nciLocation
(L
ON
M
ARK
) or
Object_Name
(BACnet) property.
Type
: Displays the type of the DALI device.
Nominal Power
: Displays the nominal power for DALI lamps. Some DALI
ballasts report their nominal power. For DALI ballasts which do not support this
feature the nominal power can be configured by the configuration property
nciNominalPwr
(L
ON
M
ARK
) or
Nominal_Power
(BACnet) of the corresponding
fieldbus object.
Status
: This column displays the status of the DALI device and the current value.
In addition the battery charge is displayed for self-contained emergency lights
providing this information.
Short Address
: DALI short address which was assigned to the device by the
L-DALI.
Serial Number
: This column displays the serial number of the DALI device if
available. Not all DALI devices have a serial number.
Buttons
: Each DALI device providing some means of visual feedback can be
winked. The wink duration can be configured. DALI lamps can be switched
on/off manually. DALI light sensors can be calibrated (see Section 5.3.4.6). If
