L-DALI User Manual
38
LOYTEC
Version 5.2
LOYTEC electronics GmbH
to calibrate the sensor with a single light condition which is near the setpoint. In this quick-
start only one lux measurement is performed.
1.
In the LINX Configurator software switch to the
Parameters
tab.
2.
Select the light sensor index 0 and click on the
Calibrate Light Sensor…
button as
shown in Figure 26. The light sensor calibration window as shown in Figure 27 in
displayed.
Figure 26: Parameterize Light Sensor.
3.
Measure the current lux level at the reference area (e.g. desk) using a luxmeter.
4.
Enter the measured lux level in the input field and select the index 0.
5.
Press the
Calibrate
button.
6.
Close the dialog by pressing the
Done
button.
Figure 27: Calibrate Light Sensor.
3.5 Configuration using Web Interface
As an alternative to the LINX Configurator PC Software the Web interface of the L-DALI
can be used. In a Web browser enter the IP address as set up in Section 3.3.
