24
Make sure there is one washer on each side of the transducer, inside the
bracket. Slide the other washer over the end of the bolt and screw on the nut.
Screw the suction cup onto the bracket using the supplied screw and
flat washer. Tie the nylon cord through the hole in the top of the
bracket. When using the transducer, tie the other end of the nylon cord
to the boat. This will help prevent losing the transducer if it comes off.
Portable transducer assembly: rear view (left) and side view (right).
Clean the chosen area of the hull before attaching the suction cup. Lo-
cate the transducer on the hull as shown in the following figure. Don't
let the bracket extend below the hull, because water pressure against it
can cause the suction cup to come off at speed.
NOTE:
For optimum operation, the portable transducer should be adjusted
so that it is parallel to the ground. For more information on this,
see the segment in the unit's operation manual on Transducer Ori-
entation and Fish Arches.
Moisten the suction cup, then press it onto the hull as firmly as possi-
ble. Tie the nylon cord to the boat and set the power pack and sonar unit in
a location for easy viewing. Your portable sonar is now ready for use.
Tie
nylon
cord
here
Washer
Washer
Nut
Bolt
Screw
Suction
cup
Transducer
