7
ASSEMBLY INSTRUCTIONS
Black (hot)
White (neutral)
Bare/Green
(ground)
Black
Blue
Whit
e
Green
9
11
10
12
WARNING: Do NOT
wire the fan motor to a
variable-speed (dimmer)
wall control.
Canopy
Round
Hole
Mounting
Bracket Screw
J-shaped Slot
10. Raise the canopy, ensure the two mounting bracket
screws are aligned with the J-shaped slots in the canopy.
Then turn the canopy in a clockwise direction until the
mounting bracket screws are completely engaged in
the J-shaped slots. Install the two previously removed
mounting bracket screws in the round holes. Securely
tighten all four mounting bracket screws.
Blade Screw
Motor Screw
Blade
Washer
Blade Arm
Blade Arm
Blade
Screw Cap
11. Insert the blade screws along with the blade washers
through the blade arm and the blade and secure with a
screw cap. Repeat this step for the remaining blades and
blade arms.
12. Secure the blade arm to the top side of the motor
using the previously removed motor screws. Completely
secure each blade arm to motor before moving to the
next.
9. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the green wire from the downrod and mounting
bracket to the bare/green (ground) supply wire.
• Connect the white wire from the fan to the white
(neutral/common) supply wire.
• Connect the black and blue wires from the fan to the
black (live/hot) supply wire.
Note: If there is a second hot/power wire coming from the
outlet box, connect it to the Blue (light power) fan wire for
separate light and fan control.
Important: After the connections have been made, the
connected wires should be turned upward and pushed
carefully up into the outlet box. Place the black and white
wire connections on opposite sides of the outlet box.
