Lovi Prolactis 3D Soft, Instruction Manual

Page: 7 / 11

12 13
GB
Hold the breast pump body with the funnel (3) as shown in
the picture.
Make sure the hole with thread is facing up.
Place the silicone massage cushion with the valve (2) in
the funnel pointing the valve towards the funnel. Then
place the valve gently into the breast pump body by lightly
pushing it down. Place the massage cushion on the funnel
and make sure that the edges of cushion fit evenly to the
edges of the funnel. Take a note that both elements are
profiled and should be properly matched to each other.
NOTE! The cushion with the anti-backflow valve should be
assembled very gently.
Screw the bottle adapter to the
bottle (14). Screw the whole set
into the breast pump body.
Place silicone diaphragm in the
goblet of breast pump body.
Then place the cover on the
breast pump body and rotate
in a clockwise direction in such
a way that the hole for the tube
connector will be located on the
opposite side of the funnel.
Place a complete set on the
base (10).
Connect the tube connectors (8)
with the tube (6) by placing their
thinner ends in the tubing. Note
that elements should tightly fit
to each other.
Connect tube with connectors with the breast pump and
pump unit. Put one end in the opening of the cover and
the second in the port placed on the control panel. Press
connectors to ensure that they fit in the openings tightly.
POWER OPTIONS
Using AC adapter
Place AC adapter ending in the port placed on the pump
unit and then plug the AC adapter into an electrical outlet.
The AC adapter for the breast pump is 5V 1A.
AC adapter pins may vary depending on the country.
It is recommended to use the original AC adapter which was
provided with the breast pump.
However, the most of adapters of mobile phones are also 5V
1A or 5V 2A. They can be connected with the USB cable of the
breast pump. It can damage the pump unit if the other adapter
is more than 5V.
Important! Before using other adapter, you should pay attention to the voltage of it first .
The above concerns countries where the EU adapter (which is included in the set) does not operate.
Using Li-ion battery
Charging the battery is done by using the AC adapter. Charging takes approx. 3 hours.
NOTE! Before first use, fully charge the battery. One full charging of the battery allows the pump to operate for approx.
1 hour (about 2/3 sessions). To extend the life of the breast pump, charge the battery before it is completely discharged.
When the battery powers the pump unit, the display shows the current charge status. The current battery charge status is
displayed in the dynamic form. When the battery runs low, you will hear a beep and the icon will flash. A used battery can
only be replaced by an authorized manufacturer’s service centre.
INSTRUCTION MANUAL
Before each use:
• Wash your hands thoroughly before using the breast pump.
• Ensure that the pump is pre-washed and dried, if not, follow the instructions below.
• Ensure that there is no liquid or moisture in the tube. Never switch on the pump if you notice any water in the
tube. Note! Do not mouth blow the tube to remove water.
NOTE! Before expressing check the charge level of the battery.
If the battery is running low, connect the AC adapter to the pump unit and let the battery recharge.
ASSEMBLING LOVI ELECTRIC BREAST PUMP
For your child’s safety and health
WARNING!
Continuous and prolonged sucking of fluids will cause tooth decay.
Always check food temperature before feeding.
Throw away at the first signs of damage or weakness.
Keep components not in use out of the reach of children.
Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
Never use feeding teats as a soother.
Always use this product with adult supervision.