12
13
GB
Place the anti-return valve (12) in the breast pump body (5).
Press down, making sure it fits tightly.
Screw the bottle (14) with the bottle adapter (17) onto the
breast pump body (5). Place a complete set in the bottle
stand (13). Remove the plastic cover of the funnel.
The tube has 2 connectors at the ends. Connect one end to
the tube connector (7) located in the cover (6) and the other
end to the pump unit (11). Make sure they are connected
tightly.
Connect the USB charging cable (9) to the breast pump unit
(11) and the AC power adapter (8). The LEDs on display will
come on and off, which means that the breast pump is in
the standby mode, and the device will start charging the
battery.
SOUND WARNINGS
1. Each time any button is pressed, the pump unit makes a beep sound.
2. When the battery runs out, you will hear a beep and the breast pump will turn off after 10 seconds.
3. If you press the mute button (7), you will turn the sounds on or off.
5
12
6
7
11
8
9
11
5
17
14
13
POWER OPTIONS
Using AC adapter –
place AC adapter ending in the port placed on the pump
unit and then plug the AC adapter into an electrical outlet.
The breast pump comes with a 5V 1A power adapter. AC
power adapter pins may vary depending on the country of
destination. It is recommended to use the original AC power
adapter that was included with the breast pump. However,
most mobile phone chargers are also 5V 1A or 5V 2A. They can
be connected via the USB charging cable. If the adapter is more
than 5V it may damage the product. Important! Before using a
different adapter, check its voltage. The above indication is for
countries where the EU adapter (supplied) does not work.
Using Li-ion battery.
Charging the battery is done using the AC power adapter and takes about 3 hours.
NOTE!
Before first use, fully charge the battery. When fully charged, the breast pump can run about 2/3 cycles. To extend
the life of the breast pump, do not let the battery run down fully. When the battery powers the pump unit, the display
shows the current charge status. The current battery charge status is displayed in the dynamic form. When the battery
runs low, you will hear a sound signal, and the icon will flash. A used battery can only be replaced by an authorised
manufacturer’s service centre.
USER MANUAL
Before each use:
• Wash your hands thoroughly.
• Ensure that the breast pump is pre-washed and dried, if yes, follow the instructions below.
• Ensure that there is no liquid or moisture in the silicone tube. Never switch on the pump if you notice any water in
the silicone tube. Warning! Do not mouth blow the silicone tube to remove water.
NOTE!
Before expressing check the charge level of the battery.
If the battery is running low, connect the AC adapter to the pump unit and let the battery recharge.
1. Place the breast pump on your breast so that the nipple is
deep inside the funnel (exactly in the middle).
NOTE!
The silicone cushion must cling tightly to the breast.
Otherwise, the suction may be reduced.
Summary of Contents for Expert 3D Pro
Page 11: ...20 ...
