Loveshaw MicroJet 5x5, Technician Manual

Page: 15 / 46

10 MicroJ et T rouble-S hooting G uide
F igure 1. P in extraction.
Head:
L ow ink lamp/res ervoir lead removal
T o remove either low ink lamp leads or reservoir leads from the
four pin connector, follow steps as listed:
* T urn unit off.
* Open lid.
* R emove ink bottle; place cap on bottle and set aside
* R emove two screws from pump cover, one on each edge, and
set aside.
* Disconnect four pin connector from modular board to
lamp/reservoir leads by pulling male
and female of connector apart.
* If a pin extraction tool is not
available, use a fine point object (i.e.,
an X -acto™ knife), to push two locks
of male pins inward towards pin body.
* A s locks of pin are being folded in,
firmly tug wire away from connector.
* R epeat for each pin removed.
* Firmly tug wire away from connector.
* R epeat for each pin removed.
Head:
A ir pump pres s ure adjus tment
* T urn unit off.
* Open lid.
* R emove ink bottle; place cap on bottle and set aside.
* R emove two screws from pump cover, one each edge, and set
aside.
Copyright © Loveshaw 2004, All Rights Reserved