Assembling instrunctions and maintenance
SECTION 1: GENERAL INSTRUCTIONS AND SAFETY PRECAUTIONS
- No.1 C DN40 / DN50 / DN65 zone manifold
- No. 1 general instructions sheet
Consult this manual carefully before proceeding with any intervention on the equipment.
The manufacturer, in order to adapt to technological and equipment needs of the productive character or installation, may, without notice, make
modifications to it.
Therefore, although the illustrations in this manual can differ slightly from the equipment in your possession, safety is the same guaranteed.
This manual is part of the product and should be adequately stored so that it could be consulted during the lifetime of the equipment.
Keep the instructions with the product if you are transfering to another owner.
Preliminary checks
Before each operation carefully remove the packaging and check the integrity of the equipment. If you note some defects or damages do not install
it or attempt to repair the equipment, but contact your dealer.
Installation
All operations on the product must be made with power disconnected from the mains.
Installation should be done in accordance with the laws and regulations of each country.
Producer responsibility is limited to providing the equipment. Its installation should be made in conformity with the rules of art, according to the
requirements of these instructions and the rules of their profession by qualified staff, acting under suitable companies to take full responsibility of
the whole plant.
LOVATO S.p.A. is not responsible for the product modified without permission, and for the replamcements of no-original components.
Please follow theese tips:
• Do not touch hot parts of the module such as pipe inlet and outlet of water. Every contact
with them can cause dangerous burning.
• Do not expose the unit to spray water and other liquids.
• Do not place anything on the unit.
• Do not expose the unit to vapors from a cooking surface.
• Prohibit the use of the equipment for children and inexperienced people.
• Do not touch the appliance with wet or damp parts of the body and / or bare feet.
• Do not pull the wires.
Installation, connections and testing must be done by qualified staff who works in accordance with the standards and follows the
instruction manual. All piping should be insulated in accordance with the law.
Hydraulic connections
After delivery of the product, ensure the tightening of all nuts fixing the pipes.
Be especially careful when you are connecting the piping kit to the hydraulic module, and avoid to bend the copper pipes.
PACKING LIST
GENERAL INSTRUCTIONS AND SAFETY RULES
!
!
Support feet kit separately supplied
Bride screws and gaskets kit separately supplied
