Louroe Electronics VERIFACT L-DT Installation And Operating Instructions Download Page 4

MANUFACTURED

IN THE

Page 4 of 4

LOUROE  ELECTRONICS    6 9 5 5   VA L J E A N   AVENUE,  VAN  NUYS,  CA  91406

TEL  (818)  994-6498

FAX 

994-6458

website: www.louroe.com                          e-mail: [email protected]

   

   

(818)

®

LD-T_mic-inst_4/11

WARRANTY

LOUROE ELECTRONICS  warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS  to be free of defects in material and workmanship.  
Should a defect appear within one year (12 months) from date of shipment, LOUROE ELECTRONICS  will, at its sole discretion, repair or replace the defective equipment.  
This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS .

This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation 
instructions provided by LOUROE ELECTRONICS.

Returned shipments to LOUROE ELECTRONICS  shall be at customer’s expense.  LOUROE ELECTRONICS  will return the equipment prepaid via best way.

®

®

®

®

®

®

IMPORTANT NOTICE

When this equipment is used as part of an 
audio monitoring system, the law requires 
that  the  public  be  given  notice  of AUDIO 
MONITORING  ON  THE  PREMISES.    A 
decal  notice  is  included  with  each 
microphone shipped.

Federal Law References:
Federal  Regulations,  US  Code,  Title  18.   
Crime and Criminal Procedure, Sec 2510.

AUDIO 

MONITORING

On 

These Premises

®

Summary of Contents for VERIFACT L-DT

Page 1: ...er manufacturers color code may vary VERIFACT L DT MICROPHONE INSTALLATION AND OPERATING INSTRUCTIONS VERIFACT L DT SPECIFICATIONS Sensitivity microphone preamp Frequency response Output Current drain 80 dB SPL input provides 0 254V RMS 40 Hz to 15 kHz 1 dB 4 mA Supply voltage 12 Vdc Weight net 0 5 Lbs 0 2 kg Output impedance Microphone housing High impact ABS Dimensions US Metric 12 cm L x 7 6 cm...

Page 2: ...op or any flat surface It has a weighted bottom with rubber padding for positive grip For best results persons should be 2 4 ft 0 6 m 1 2 m from the microphone MICROPHONE POSITIONING Model L DT connects directly to any Louroe base station or audio interface adapter A terminal block is located on the back of Model L DT Microphone housing marked A B C A is 12 Vdc power B is Audio Output C is Ground ...

Page 3: ...o L position Model L DT is always shipped with sensitivity switch in the N position Do not change unless necessary 2 Conductor shielded cable 22 gauge with a 24 gauge drain wire NOTE Unshielded cable is not satisfactory for audio systems WIRING REQUIREMENTS West Penn 452 or equivalent All Louroe Microphones Audio Base Stations and Audio Interface Adapters contain 3 pin terminal blocks marked A B C...

Page 4: ...air or return without prior notification by LOUROE ELECTRONICS This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation misuse accident or in violation of installation instructions provided by LOUROE ELECTRONICS Returned shipments to LOUROE ELECTRONICS shall be at customer s expense LOUROE ELECTRONICS will return the equipment prepaid via be...

Reviews: