background image

CONNECTION DIAGRAM

Verifact

 C 

Microphone

NOTE:
This microphone is NOT 
recommended for outdoor 
use or in areas with high 
moisture content

TO LOUROE 

BASE STATION 

OR AUDIO AUDIO 

INTERFACE 

ADAPTER

RED

 wire (12 Vdc) connects to Terminal A

BLACK

 wire (Audio) connects to Terminal B 

 wire (Ground) connects to Terminal C

BARE

If using recommended wiring (West Penn 452)

 MICROPHONE SENSITIVITY SWITCH

The microphone pre-amp (PC board) contains a sensitivity switch with two positions:

N represents normal sensitivity (zero dB @ 1,000)

L represents lower sensitivity (-6 dB @ 1,000)

Microphone is always shipped in the N position.  For less microphone sensitivity, 
move slide switch to L position.  Do not change unless required.

INSTALLATION TIPS

1. Use overall shielded audio cable only. West Penn 452, Belden 8451 or equivalent. 

UNSHIELDED CABLE IS NOT SATISFACTORY FOR SOUND SYSTEMS.

2. When used at a cash register checkout, microphone should be installed closer to the customer rather than the cash 

register, as the drawer sound could dominate the recording. It should be installed closest to the 

area to be monitored and documented.

3. Avoid installing microphone near air vents, air conditioners, fans and other equipment that generate 

high sound and air pressure.

4. If microphone is installed in a police interview room, room should be conditioned with any type of carpeting, acoustical 

ceiling tiles, acoustical foam, etc. to reduce echo.  This will enhance the quality of live and recorded audio.

5. The APR-1 and microphone should have a barrier or solid wall between them in order to avoid audio 

feedback, especially when they are in close proximity to each other.  If no barrier, microphone should be at least 25’ 

from APR-1 to avoid acoustical feedback.

2 Conductor 

shielded

 cable, 22 

gauge with a 24 gauge drain wire

NOTE:

Unshielded cable is not 

satisfactory for audio systems

WIRING REQUIREMENTS

West Penn 452 or equivalent

A (12 Vdc)
B (Audio)
C (Ground)

A

L

C

B

N

Page 3 of 4

LOUROE  ELECTRONICS    6 9 5 5   VA L J E A N   AVENUE,  VAN  NUYS,  CA  91406

TEL  (818)  994-6498

FAX 

994-6458

website: www.louroe.com                          e-mail: [email protected]

   

   

(818)

®

C_mic-inst_4/11

INSTALLATION AND OPERATING INSTRUCTIONS

Summary of Contents for Verifact C

Page 1: ... ft 305m from the Louroe Base Station or audio interface adapter 2 Conductor shielded cable 22 gauge with a 24 gauge drain wire NOTE Unshielded cable is not satisfactory for audio systems WIRING REQUIREMENTS West Penn 452 or equivalent MODEL C MICROPHONE C_mic_inst_4 11 MICROPHONE ELEMENT RUBBER GROMMET VERIFACT C MICROPHONE INSTALLATION AND OPERATING INSTRUCTIONS 6955 VALJEAN AVE VAN NUYS CA 9140...

Page 2: ...Solder on an RCA connector with wire from terminal B of microphone going to the tip of the plug and wire from terminal C of microphone going to the sleeve of RCA plug 4 Connect RCA plug into Audio In jack of DVR or soundcard Microphone pre amp is mounted in a protective plastic housing with openings for wire connection and microphone sensitivity adjustment If microphone is to be mounted in a speci...

Page 3: ...register as the drawer sound could dominate the recording It should be installed closest to the area to be monitored and documented 3 Avoid installing microphone near air vents air conditioners fans and other equipment that generate high sound and air pressure 4 If microphone is installed in a police interview room room should be conditioned with any type of carpeting acoustical ceiling tiles acou...

Page 4: ...N NUYS CA 91406 TEL 818 994 6498 FAX 994 6458 website www louroe com e mail sales louroe com 818 C_mic inst_4 11 WARRANTY LOUROE ELECTRONICS warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS to be free of defects in material and workmanship Should a defect appear within one year 12 months from date of shipment LOUROE ELECTRONICS will at its sole discretion repair or...

Reviews: