3
Shooting:
Camera gimbal cannot output film picture; should supervise it on the ground; should add HDMI
convert AV mode. The mould will be provided soon (optional)
The HDMI output of camera set up:
1. Make the camera HDMI Resolution ratio setup ”Automatic“
，
save it ,exit the camera setup
menu. Then turn off the camera.
2. Please connect HDMI convert card or related cable. Turn on the camera, make it works.
3. If there is no image, please check the resolution ratio if is under the “automatic “mode, that is
to say, it is check have you save the set up at the first step. If it is failed, please redo first step.
4. There are some area camera need setup video mode should be change to PAL. This depends on
camera firmware.
No Image output reasons as following:
a. User first use the camera, first connect HDMI card, then setup camera HDMI Resolution ratio. If
you do like this, the camera cannot output the image. You should need disconnect the HDMI
card, setup the HDMI resolution ratio. Then save it, turn off the camera.
b. There is image output, but screen roll. This is because our convert card output is PAL model
signal, need user’s screen support PAL model signal. Most of screen can support PAL signal.
