INSTRUCTIONS FOR INSTALLATION
The data plate is attached to the rear panel (see drawing under "electrical connection" ) and contains all the
information necessary for the connection.
INSTALLATION
The main switch or the outlet must be in the vicinity of the appliance and easily accessible. If the appliance is
placed near walls or partitions, kitchen furniture, decorative coverings, etc. it is recommended that these be
flameproof or coated with flameproof material. Above all, fire prevention regulations must be observed.
Provisions of the law,
technical rules and regulations
The installation must be carried out in accordance with the following standards:
-The accident prevention and electrical legislation in force.
- Fire department regulations
Installation
The installation, start-up and maintenance of this appliance must be carried out only by qualified personnel. All the
installation operations must be in accordance with the standards in force.
The manufacturer declines all responsibility for poor functioning due to incorrect installation or non-observance of
the regulations.
Warning
: International provisions require that during the connection of the appliance there be a device which allows
the bi-polar disconnecting of the appliance from the network, upstream from the appliance. This device must have
a contact opening of at least 3 mm.
RI - 4 EM
41
ELECTRICAL CONNECTION
The appliance is supplied with
RXW
the connection cable. proceed in the following manner:
- turn off the power.
- remove the reflecting panel
- pass the new connection cable throught the cable clip, connect the wires in the corresponding terminal of the
terminal board and fix them
- lock the cable with the cable clip and reassemble the reflecting panel. The earth wire must be longer that the others
so in case the cable clip breaks, this disconnects after the tension cables
N.B. The connection cable must have the following characteristics:
it must be at least of the H05 RN F type
and have a section suitable for the appliance power (see technical specification table)
