Lotus PCID-44ET, Instructions For Installation And Use Manual

Page: 46 / 67

46
GB IE
GENERAL TECHNICAL DATA
Minimal pan diameter: 120 mm
Relative humidity: 10% to 90% non-condensing
Operation Ambient temperature: 0°C ÷ 40°C
Voltage tolerance:
Supply frequency: -10% ÷ +6%
50 – 60 Hz
TECHNICAL DATA TABLE
MODELS
PCID-64ET… PCID-68ET… PCIWD-64ET… PCID-84ET… PCID-44ET… PCID-88ET…
DIMENSIONS cm 40x60x31h 80x60x31h 40x60x31h 40x80x31h 40x40x31h 80x80x31h
POWER SUPPLY
400V~3
50/60Hz
400V~3
50/60Hz
400V~3
50/60Hz
400V~3
50/60Hz
400V~3
50/60Hz
400V~3
50/60Hz
MAXIMUM ABSORPTION A
14,4 A 29 A 7,2 A 14,4 A
7,2 A
29 A
MAXIMUM POWER kW
10 kW 20 kW 5 kW 10 kW
5 kW
20 kW
POWER SUPPLY CABLE 4x1,5 mm² 4x4mm² 4x1,5 mm² 4x1,5 mm² 4x1,5 mm² 4x4 mm²
MINIMUM VENTILATION IN 100 cm² 165 cm² 50 cm² 100 cm² 50 cm² 165 cm²
MINIMUM VENTILATION OUT 150 cm² 200 cm² 82 cm² 150 cm² 82 cm² 200 cm²
MAX AMBIENT TEMPERATURE
COMPARTMENT GENERATOR
35°C 35°C 35°C 35°C 35°C 35°C
INSTRUCTIONS FOR INSTALLATION
The data plate is on the front (see diagram in electric connection item) and has all the data necessary for the connection.
INSTALLATION
When fitting, the appliance must be leveled using a spirit level; slight differences of level can be adjusted by screwing
or unscrewing the adjustable feet. The main switch or the socket must be near the appliance and easily accessible.
It is advisable to place the appliance under an extractor hood so that steam is extracted rapidly. If the appliance is placed
near walls, dividing panels, kitchen furniture, decorative finishes, etc., these should be in flameproof material; otherwise
it is necessary to cover them with non-flammable material.
Above all, it is necessary to ensure that fire prevention standards are observed.
Always comply with the following points during installation:
- Ensure that mains voltage complies with the voltage indicated on the specification table of the
appliance
- All electrical installations must comply with local standards. All standards issued by national electrical authorities
must be complied with.
- When circuit breakers are used, they must be suitable for a minimum of 30 mA.
- Avoid obstruction of air intakes or outlets with objects (fabric, walls, etc).