Lotus MS 9120 A TOP, Instructions Booklet For Installation Maintenance Operation

Page: 29 / 42

8
Installation, initial start-up and maintenance of the appliance must be carried out by qualified personnel only.
All hydraulic and electrical connections must be carried out in compliance with current safety norms. The
manufacturer accepts no responsibility for malfunctions arising from incorrect connection of the appliance.
When installing, ensure that the appliance is perfectly level. Turn the adjustable feet clockwise or
anticlockwise to level the appliance.
The following norms must be observed when installing the appliance:
1. current accident -prevention regulations
2. CE standards
3. water board regulations.
The electrical panel is located on the front of the appliance. The connection to power supply is on the back
side of the appliance. The power cable (G) must have a rating of at least H07RN-F, and each wire must have
a section of 2,5 mm².
N.B.: In accordance with international standards, a cut-out switch (A), provided with amperage-adequate
fuses (see technical specification), must be installed between the mains electricity supply and appliance. The
contacts must have an aperture of at least 3 mm.
The main switch (A) should be positioned in the immediate vicinity of the appliance and should be easily
accessible.
Fig. 2-1
The appliance must be grounded. The ground terminal screw is located on the rear panel of the appliance,
and marked by the symbol .
N.B.: The manufacturer accepts no responsibility or warranty obligations in case of damage arising from
non-compliance with this requirement or from incorrect installation.
2. INSTALLATION
2.1 CONNECTION TO POWER SUPPLY
2.1.1 GROUND