AMC73 – AMC73B
©Copyright Lotronic 2019
8
DESCRIPTION PANNEAU DE CONTROLE :
DESCRIPTION MICRO HF :
MONTAGE :
INSTALLATION 1 : The bottom is provided with rubber foot to adjust the lectern position as
wished
If it fixe on the floor, unscrew rubber foot and use small clamp.
Screw bottom on column with the three screws.
INSTALLATION 2 : Put the wire connector on the upper part on the corresponding socket on
the column and screw the security ring.
INSTALLATION 3 : Install the receiver support
INSTALLATION 4 : Install the wireless receiver on the support.
INSTALLATION 5 : Put the upper part on the support and screw the four screws. Install
gooseneck min and gooseneck light on the upper part.
Adjust antennas on each side.
1. BATTERY LED
This led shows you a visual information about battery level. If the led lights on, that means
the battery is ok, if the led don’t light on or if it shine slightly, that means you must replace
the battery.
2. ON//MUTE/OFF SWITCH
This switch have three position, in OFF position, the mic is OFF and no sound is transmitted.
In the Mute position, the mic is on but no sound is transmitted. In ON position, the mic is on
and the sound is transmitted.
3. BATTERY PLACE
4. BATTERY COVER
Unscrew the battery cover, insert the new battery (respect the polarity)) and screw the
cover.
If you switch the wireless mic on and the wireless transmission is not available, you must to check
several points:
-
The operating range must be less than 30m. Keep this distance to have a good operating.
-
Check if the conference lectern is on
-
Adjust antennas
-
Check if the mic and receiver frequency is identical.
A. MIC 1 LEVEL CONTROL
Use to adjust Mic1 level control
B. MIC 2 LEVEL CONTROL
Use to adjust Mic2 level control
C. MIC 3 LEVEL CONTROL
Use to adjust the wireless Mic3 level control
D. MIC 2 INPUT
Connect a microphone to this input.
E. PRE OUTPUT
Use this output to connect an amplifier or a powered speaker
F. AUX INPUT
Use to connect a line level device such Cd player, MP3 player…
G. LINE OUTPUT
Use this output to connect an amplifier our a recorder
H. TREBLE TONE CONTROL
Use to adjust the high frequency tone level
I. BASS TONE CONTROL
Use to adjust the level of the AUX input
J. AUX LEVEL CONTROL
Use to adjust the high frequency tone level
