15
WELDNG WIRE INSTALLATION
The MIG140 welding machine can use wire spools up to 8“ diameter (200mm) and a maximum
width under 2” (50mm). If you use the smaller 4“ diameter (100mm) wire spools the 2” (50mm)
spindle adapter must removed.
For installation of a 8” (200mm) welding wire spool (See Figure D-1).
Install the 8“ (200mm) welding wire spool on the wire spindle
○
1
○
2 making sure the wire spool
spindle tab engages the hole in the wire spool. (Note: The wire spool will rotate clockwise when wire
is de-reeled).
For installation of a 4“ diameter (100mm) welding wire spool (See Figure D-2).
The 2” (50mm) diameter spindle must be removed
○
2 .
○
4 Remove the wing screw
○
5 and remove
the outside plastic wire spool spindle
○
6 . A 4” (100mm) diameter spool is mounted directly on a 5/8”
(16mm) diameter shaft and held in place with the previously removed hardware.
○
7 (NOTE: The wire
spool will rotate clockwise when wire is de-reeled) Also, makes certain the start end of the welding
wire, which may protrude through the side of the spool does not contact any metallic case parts
Use the welding wire board
with 8 "(200 mm) in diameter
Figure D-1
2
1
3
Use the welding wire board
with 4 "(100 mm) in diameter
Figure D-2
4
7
6
5
Summary of Contents for MIG140
Page 1: ...1 LOTOS MIG140 MIG Welder ...
