15
/
21
MACHINE SETUP
ELECTRIC SHOCK can be fatal
Keep the plasma cutting torch and ground cable & clamp in
good condition and in safe place.
Do not touch electrically live parts with skin or wet clothing.
Insulate yourself from work pieces.
Turn the machine “off” before connecting or disconnecting output cables or
other equipment.
AIR/GAS CONNECTION
Obtain the necessary air. Connect the cylinder of compressed air or air compressor
with a pressure regulator and flow gage. The quick connector installed on the
machine is
US Industry 1/4” NPT Male Coupler Quick Connector
. It can be easily
connected to your air compressor.
The installed rear is shown in Figure A.1.
CYLINDER could explode if damaged
Keep cylinder upright and chained to a support.
Keep cylinder away from areas where it could be damaged.
Never allow the torch or welding electrode to touch the cylinder.
Keep cylinder away from live electrical circuits.
Consumables installation
The consumables set of electrode, nozzle and cup should
install in order as shown in Figure A.2.
The LT3500 can only use genuine LOTOS brand
consumables sets of LCON serial.
One set of consumables has already been installed in
the torch head.
Installed on LT3500’s Air Regulator
Air Compressor ‘s Female Coupler