6.
Check damaged parts. Before using any tool, any part that appears damaged should
be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and compatibility of all parts with your
machine, cables, accessories and parts. If any part is damaged it should be replaced
before operating the machine for safety precaution.
7.
Replacement parts and Accessories. When servicing use only identical and
guaranteed authentic Lotos replacement parts. Use of any other parts will void the
warranty.
8.
Approved accessories and parts are available from Lotos Technology only. Please
contact our customer support team if you require assistance.
ASSEMBLY
Follow assembly instructions carefully. Deviation from safety and operation precautions can result in
fire, explosion, damage to equipment or injury to the operator.
Compressed Gas Cylinders & Regulators:
1)
Place and secure the cylinders together where they will be used (on a welding cart, wall, work
bench or post with chains). Cylinders must remain in a vertical position and must always be
properly secured.
2)
Remove protector cap from each cylinder and examine the outlet nozzles closely. Make sure
that connections and screws are not damaged or can cause a leak.
3)
Clean cylinder valves by cracking. In order to clean the cylinder valve briefly open and close
“crack” each cylinder valve to dislodge any dirt, dust or rust that may be present. These
particles if not cleaned out will drift into the regulator when the valve is opened. Wipe
connectors with a clean cloth.
4)
Examine hoses carefully before each use. If there are cuts, burns or worn areas on the hose
it will need to be replaced. Fittings should also be checked for damage. If any damage is
found the parts will need to be replaced for proper function and safety assurance.
