SET UP INSTRUCTIONS FOR THE LORICRAFT AUDIO RECORD CLEANING SYSTEM
1. Remove the machine and accessories from shipping carton. Be careful to avoid any damage to vacuum arm and the smaller parts.
2. Place the machine on a level surface where you intend to operate the machine.
3. Place the fluid jar on the machine base and secure the jar with the elastic "hooked" spring cord. See photo for placement.
4. Connect the large 6mm clear tubing to the inlet fitting on the side of the machine base. The other end of the tubing is already connected to jar lid.
The 6mm tubing will fit only one of the nipple fittings on the top cover of the jar.
5. Connect the 3mm clear tubing to the smaller nipple on the jar lid. The other end is already attached to the arm. Rotate the jar until the 3mm tubing
is to the rear of the base cabinet. The elastic cord jar retainer will hold the jar in place for easy removal in the future.
6. Switch on the vacuum pump and draw the nylon thread into the fluid evacuation jar. You should see a few inches of thread in the jar before
starting to clean records. As you use the thread the spent thread will be sucked into the used fluid jar.
7. Balance the arm as you would a phono pickup arm by adjusting the weight on the end of the arm. Use just enough weight to keep the arm from
bouncing. The ideal weight is about 2.5 grams and can be set with the same stylus pressure gauge you use for your phono tonearm.
