STEP 1:
Initial Setup
To prepare the cameras:
Before you begin, you will need to prepare the Wire-Free cameras and Power Packs.
2. Peel off the
PLEASE REMOVE
label covering the contacts
on each Power Pack. Insert the charged Power Packs
into each camera base. Push up until the Power Pack
‘clicks’
into place.
1. Twist the adjustment ring counterclockwise to reposition
each camera as shown to the right. Connect one of the white
antennas to each camera.Twist clockwise to tighten when
finished.
STEP 2:
Pairing with Lorex Cirrus
To pair the camera with Lorex Cirrus:
Next, you must pair your add-on camera to your recorder using the Lorex Cirrus app for
smartphones and tablets (iOS and Android).
NOTE:
Make sure the camera is within 3ft (1m) of the recorder.
NOTE:
The camera will
'beep'
when the Power Pack is
properly inserted. If you do hear this alert, remove the
Power Pack by pushing on the release tabs then re-insert.
U222A_QSG_EN_R1
1. From Live view, tap any
free channel you would
like to pair a camera to
(marked with a
icon).
2. Tap
PAIR
.
A timer for 30
seconds appears.
3. Press and hold the
pair button on the
back of the camera for
3 seconds.
NOTE:
A “pairing successful” message should appear on screen. If you do not see this message,
repeat the steps above.
To install your cameras:
1. Set the mounting bracket in
the desired mounting position.
Mark holes through the
mounting bracket (shown as
blue X’s on the right).
2. Drill holes where marked for
the mounting screws using
the included drill bit (item C
provided in the toolkit with your
wire-free system).
3. Secure the bracket to the
mounting surface with the
included mounting screws
(×4). Make sure all screws
are fastened tightly using the
included screwdriver (item
A+B provided in the toolkit
with your wire-free system).
NOTES:
• Insert the included drywall anchors if you
are mounting the camera onto drywall.
• The hole at the top of the mounting
bracket will be used in step 5, once the
camera is attached to the mounting plate.
STEP 3:
Installing the Cameras
Follow the instructions below to mount the cameras. It is recommended that you refer to the “Installation Tips” section to
help you select good mounting locations.
4. Lower the camera base
onto the mounting
bracket so the 2 tabs in
the mounting bracket
lock into the 2 slots in the
camera base.
6.
OPTIONAL:
To prevent
the pre-installed
locking screw from
being easily removed,
tighten it on the base
of the Power Pack
using the included
screwdriver (item A+B
in toolkit).
7. Adjust the angle of
the camera. Twist
the adjustment ring
counterclockwise to
reposition the camera.
Tighten the adjustment
ring when finished.
8.
OPTIONAL:
Use the included cable clips to complete the installation. Remove
the protective strip to uncover the adhesive on the cable clip to attach to the
mounting surface.
NOTE:
You will need to
loosen the locking screw
to remove the Power Pack
in the future.
5. Insert the security screw
through the fasteners on
the top of the camera base
and mounting bracket
to secure the camera to
the mounting bracket.
Tighten using the included
screwdriver (item A+B
provided in the toolkit with
your wire-free system).
Adjustment ring
Power
cable
Mounting surface
NOTE:
Power Packs come fully charged.
Adjustment ring
*
*
