CAMERA INSTALLATION
Option 1
: You can place the camera on a desk or any leveled surface.
Select a location that is near an AC outlet and within reach of the AC
adapter cord. You can adjust the camera head vertically to the best viewing
angle.
Option 2
: For wall mounting, use the supplied mounting bracket and
screws. First, attach the stand to the wall where you want to install the
camera and drive the 2 supplied screws into the wall. Attach the camera to
the stand and firmly tighten the swivel. Adjust the camera to the best
viewing angle.
Power-Up the Camera
: Once the camera is mounted in place, connect the
supplied 6V DC 300 mA to the DC IN jack at the side of the camera, and
plug it into an electrical outlet.
You also have the option of using 4 “AA” alkaline batteries in your camera.
To utilize the battery option, follow these steps:
1. Ensure the power button on the camera is depressed to OFF.
2. Loosen the screw at the back of the camera and remove the cover.
3. Insert 4 “AA” batteries (not included) into the battery compartment while
noting the polarity (+ / - symbols).
Warning: to prevent damage to the unit, ensure the batteries are
aligned properly and battery types are not mixed
4. Close the compartment by re-screwing it, and turn the camera “ON”.
4
WALL
DESK
Ensure the power switch on the monitor and camera are set to
the OFF position before proceeding with the following steps.
NOTE
OPTION #1
OPTION #2
