15
3.
Position the stabilizer in front of, and to the inside of the gang, when looking at the
cultivator from the front. Remove the
5/8
” U-Bolt from the inside angle gang
bracket. Match the stabilizer bracket holes so the two outside holes align with the
two inside angle bracket holes. Insert two
5/8
”x 9” bolts through the two outside
stabilizer bracket holes, one above the toolbar and one below the toolbar, and
through the two inside angle bracket holes. Fasten with
5/8
” lock washers and
5/8
”
hex nuts. Place the
5/8
” U-Bolt around the back of the toolbar with thread ends
inserted through the inside holes of the stabilizer bracket. Center the gang and
square the stabilizer on the toolbar row spacing mark. Secure with two
5/8
” lock
washers, and two
5/8
” hex nuts.
Fig. 8
Summary of Contents for 7S509
Page 19: ...18 Fig 9 ...
