detail
arrow
Use the phillips screwdriver to screw 8 camstuds (4 per side)
1
side
(4 per shelf)
to the top panel.
Join the bottom rail to the bottom panel and the top rail
NOTE:when attaching the bottom rail and top rail the
pre drilled holes on the unfinished (back) section of these 2
parts must face the BACK OF THE SHELF.
Note: the camlocks are tightened by turning them clockwise
3
top panel
8 camstuds
shelf pins
bottom rail
bottom panel
top rail
21 dowels
(pre installed)
into the underside of the sides, as shown.
the finished front edge of the shelf is facing to the front
When shelves are placed on the shelf pins, make sure
Insert the shelf pins at the desired levels for what you
If one side of the back panel is unfinished, put the unfinished
side facing the outside.
screws can be hammered into the holes, or with a sloted
The back panel can be attached two ways :
screwdriver.
Attaching the back panel
screw
5
back panel
wish to store.
shelves
of the Bookcase.
6
pin
Insert 4 camlocks into the top panel and 4 camlocks into
the bottom panel, with arrows facing out, as shown detail.
2
4
clock-wise to tight them.
Use the phillips screwdriver to rotate the camlocks
Connect the assembled parts to the side panels.
hole
top panel
bottom panel
A S S E M B L Y I N S T R U C T I O N S
May include spare hardware
HARDWARE
back panel
screws for
BOOKCASES
(1) Bottom rail
(1) Top rail
(2) Side panel
(1) Top panel
(1) Bottom panel
(1) Back panel
30"h = (1) Shelf
36"h = (2) Shelves
60"h = (4) Shelves
48"h = (3) Shelves
84"h = (6) Shelves
72"h = (5) Shelves
PIECES
8 camlocks
Tools required: a phillips screwdriver, a hammer and/or a rubber mallet.
