1 8
Operation
© Travis Industries
4 0 8 0 7 2 3
1 0 0 - 0 1 1 4 5
Loading Pellets
Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper
holds approximately 48 to 88 pounds of pellets (depending upon hopper set-up).
The front edge of
the hopper lid
becomes very
hot, do not touch
the area below
the handle.
Make sure pellets are
not left on this heat
shield.
AAAAAA
AAAAAA
AAAAAA
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA
AA
AA
AAAAAAA
AAAAAAA
AAAAAAA
AAAAAAA
AAAAAAA
AAAAAAA
AAAAAAA
AAAAAAA
AAAA
AAAA
AAAA
AAAA
AAAA
Pe
t
e
l
s
l
AA
AA
The Two Modes of Operation:
M a n u a l
Manual mode requires the user to turn
the heater on and off manually.
Auto (requires a thermostat)
Auto mode allows you to use a
thermostat to control room
temperature. The stove automatically
turns on when the temperature drops
below the thermostat setting. Once the
stove reaches operating temperature,
the stove then runs at the heat output
setting selected.
Switching Modes While in
Operation
Whenever the stove is switched from
one mode to another while in
operation, the stove will enter the "start-
up" sequence for a minimum of 20
minutes.
HIGH
DISCONNECT POWER BEFORE SERVICE
AUTO
MANUAL
H
E
A
T
O
U
T
P
U
T
MED
LOW
AUGER
MAINT.
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
(REQUIRED)
Use the mode
switch to
determine the
mode.
These indicator lights
are used to determine
which mode you are in.
