LOOPTROTTER SATUR-8/24, Owner'S Manual, Page: 5 / 9

DRIVE – this knob controls the level of the signal
entering the saturation circuit. Increasing the DRIVE
level results in stronger signal saturation, giving the
ear friendly distortion and audibly higher RMS level,
thus loudness. Note that the saturation level depends
also on the input signal level.
ON/OFF
– Turns the saturation module on and off.
With the saturation module engaged the DRIVE and OUTPUT
knobs are inactive.
LED METER
– indicates the amount of added
harmonics – the depth of saturation. The orange LED
lights on above the 4% THD, red LED lights on above the 8%
THD. Above 8% THD the signal saturation is clearly
audible.
OUTPUT – this knob controls the level of the signal
leaving the saturation circuit. In position 0 the signal
is muted.
LCR – this switch sets signal panning.
L- left channel ; C - central - mono ; R – right channel.
The LCR switch acts independently from the saturation
module and is active even when the latter is disengaged.
1-8 - ON/OFF – this switch turns on and off all the
8 saturation channels simultaneously. In the OFF
position the LED flashes red.
MIX - MAGIC/NORMAL – this switch activates the
„ MAGIC ” module. In NORMAL position the module is
inactive and does not influence the mixed signal.
MONITOR
– this knob controls the signal level on
the monitor output.
MAIN
– this knob controls the signal level on the
main output. The main output level is indicated by two VU
meters.
LOOPTROTTER
AUDIO ENGINEERING
Controls – Front Panel
Contact:
looptrotter@looptrotter.com.pl
www.looptrotter.com.pl
Distribution:
office@mjaudiolab.pl
www.mjadiolab.pl