21
Carbon Plate
29
Handle rivet
balance o-ring
Handle knob
Handle knob washer
30
31
balance
Spool cap o-ring
Bearing Holder
Cup spring
24
27
26
25
28
22
23
Draw bar
Spool
Spool cap
One way clutch ass'y
20
19
Steel plate
17
18
Ball bearing
3
Drag knob nut
11
Main shaft
Ball bearing
Seal ring
O-ring
Foot screw
15
16
12
14
13
Click bush
Click pin
Click spring
O-ring
Nut washer
6
8
9
7
10
4
5
Locking screw M3x5
Drag knob
2
1
Main shaft screw
Housing
Foot
7
2
6
1
3
4
5
8
10
18
17
9
11
13
12
14
19
16
15
20
21
29
23
22
24
31
30
26
25
28
27
LOOP MULTi Fly Reel Manual
CAUTION! Do not touch any moving parts of the reel when a fish is running!
Congratulations on the purchase of your new flyreel. We wish you many seasons of good use of
your new reel in flyfishing. Enclosed are instructions for proper care and maintenance. Good luck!
Conversion left / right hand retrieve:
1. Remove spoolcap (26).
2. Pull spool (24) straight out.
3. Release stopscrews (2) ½ turn with enclosed Allen wrench.
4. Pull drag knob (1) straight out.
5. Remove drag knob nut (3).
6. Pull draw bar (23) straight out, together with cup springs (22).
7. Pull bearing holder (21) straight from shaft (14).
8. Remove seal ring (15).
9. Remove bearing (16), bearing washers (17), carbon plates (20) and one way bearing (19).
10. Turn one way bearing (20).
11. Wipe clean.
12. Assemble the reverse way.
Adjust the effect of the brake:
The drag knob nut (A) allows you to adjust
the brake, in order to obtain the lowest brake
effect of preference. We recommend free
spool in both directions.
1. Turn the drag knob nut (A) until the lowest
preferred brake effect has been obtained.
2. Fasten the drag nob to the ajdustment
screw and turn the handle counter clockwise
so that the heel on the inside of the drag nob
(B) will settle to the left of the stop pin (C).
Tighten the screws on the lock with the Allen
wrench.
Maintenance of the reel:
This reel is contructed so that maintenance is kept to a minimum. However, be sure to check on the
level of grease on the O-ring (25) inside the spool cap (26), after using the reel for some time. We
recommend Molykote 111C grease or similar.
C
A
B