Loomis SafePoint i-Deposit v2
User Guide
9
Presenting coins on the device
As the unit validates the coins at speed, the placement and feed of coins is essential to its
efficient and fault free operation.
The coin module is designed for low to moderate deposits of coin, therefore is only fitted with
a small coin cup to catch, validate and process these coins. Care should be taken when trying
to feed large sums of coin in a single transaction.
Helpful tips!
The feeder can process up to 4 coins per second
Place all coins at the far edge of the coin catcher first, this will catch any dust or other
small objects as they move over the gaps
Slowly bring the coin’s forward as the unit begins to validate coins
Don’t try to push through too many coins at once, keep it slow and steady
If during the processing of coins, a coin is not recognised by the reader it will be set aside in
the rejection tray and not counted.
Visually inspect the rejected coin, check for any visible damage that may be stopping the coin
from being processed (eg. the edges of a 20p can be too rounded).
If you cannot see anything obvious preventing the coin from being accepted, simply try to
deposit the coin again.
If after several failures the coin is not accepted, then unfortunately due to the likely condition
of the coin, it cannot be validated by the security features and therefore must be set aside.
