18
EN
Hose not connected :
1 / Pass the rear brake hose through entrance 1
(Fig. 2), then pass it through the support plate (Fig. 21),
take the hose out through opening 4 (Fig. 1).
2 / Pass a foam sheath (long foam tube) onto the hose
at its exit through exit 4 (Fig. 1) until it touches with the
support sheet and fix it with adhesive tape.
3 / Pass the hose along the routing channel (Fig. 21),
then enter it through opening 5 bis (Fig. 21).
4 / Exit the hose through exit 10 (Fig. 1).
5 / Thread a short foam tube
on the brake hose
at the top of the bushing (see § Table of lengths
in chapter Mechanical routing configuration
:
A (RIM) and B (HYDRAULIC)
.
6 / Connect the hose to the caliper.
Hose pre-connected :
1 / Pass the rear brake hose through entrance 10 (Fig. 1),
then take the hose out through opening 5 bis (Fig. 21).
2 / Pass a foam sheath (long foam tube) onto the hose
at its exit through exit 4 (Fig.1) until it touches
the support sheet then fix it with adhesive tape.
3 / Pass the hose along the routing channel (Fig. 21),
then enter it through opening 4 (Fig. 21).
4 / Exit the hose through exit 2 (Fig. 2)
Rear hydraulic brakes
IMPORTANT :
There are two assembly options, the first is an assembly in which the hose is not
connected to the caliper, whereas in the second the hose is pre-connected to the caliper.
NOTE :
Your bike in the disc version is provided with 140/160 mm FLAT MOUNT standard compatible
fixing front and rear. The thickness of the base at the fixing of the rear caliper is 25 mm.
BRAKE ASSEMBLY
5 BIS
4
Canal de routage durite
Brake hose channel routing
Modification
Treatment
Date
SHEET A3
SCALE 1:10
Material
Ind.
Date
Resp
REFERENCE
PART
Cheked by
Date
Drawn by
ASSEMBLY
GENERAL TOLERANCES :
Dimension from 0 to 15 : ±0.15
Dimension from 15 to 30 : ±0.20
Beyond : ±0.25
Angles : ±30'
Surfaces finish : 80 grit sand blast
Free of positive metal, voids and porosity
Free of cutting oil and oil residue
01/01/1601
01/01/1601
01/01/1601
01/01/1601
01/01/1601
Volume (mm3)
Mass (g)
01/01/1601
Fig. 21
Fig. 22
Your 795 BLADE RS is equipped with fixings to attach two bottle holders,
one on the saddle tube and one on the diagonal tube (Fig. 22).
Remove the four M5 screws with a 4 mm Allen key. Fit the bottle holders
(refer to the relevant product manual), then tighten the screws to a torque
of
3 Nm
.
WARNING :
Use only the original screws.
HYDRATION
Summary of Contents for 795 BLADE RS 2019
Page 1: ...MA NUAL 795 BLADE RS...
Page 22: ...Ref 00021957 lookcycle com...
