9
5. Operating the Viper 2.6
The
Viper 2.6
is a powerful fog generator, producing every desired effect from
a tiny puff of smoke to the thickest fog.
Digital technology makes fine adjustments of the pump possible. In steps of
1% the output can be adjusted from 1-99%.
5.2 Putting into operation
a. Connect the
Viper 2.6
to the mains supply. Make sure the correct voltage is
selected (230 V/50 Hz). A „P” and two figures appear on the display.
b. After a warm up time of approx. seven minutes the
Viper 2.6
is ready to start.
The green Ready-Led [22] blinks if the working temperature is reached. As
soon as the final temperature is reached, the LED illumates permanently.
c. Adjust the required output via the control panel and press the Enter-button
[18] once to start the fogging process (see point 5.4).
P 2 5
5.3 Switching the device off
a. Press the Mode-button [16] til „OFF” appears on the display. After 15 seconds
the machine will switch off automatically. On the right bottom edge of the
display a red decimal point appear.
You can also switch off the machine within these 15 seconds by pressing the
Enter-button [18].
b. When you switch off the DMX signal, the machine will be switched off
automatically after 15 seconds.
.
