Longshine LCS-8038TXR7, Manual

Page: 5 / 61

2.2 Install the Adapter
1. Turn off the computer.
2. Remove the computer’s cover, in accordance to its
manual.
3. Insert the contact edge of the adapter card into the
connector of any available PCI Bus master expansion
slot. Press the card firmly into the connector to PCI slot.
Please make sure that the card’s contacts are fully
seated in the PCI slot.
4. Install the bracket screw that secures the card to the
Computer chassis.
5. Connect the WOL cable to the motherboard. (If adapter
supports WOL function)
6. Replace the computer’s cover.
7. Connect the CAT3 or CAT5 UTP cable to the RJ-45
network connector.
8. Remove [Drivers and Utilities] diskette from the PC
diskette drive.
9. Turn on the computer.
10. If the BIOS section of your computer’s boot program is
Plug and Play compliant, then at power up the BIOS will
configure any newly installed adapter automatically.
Note:
Due to some Plug-n-Play BIOS programs' problem, it
happens occasionally that a newly installed adapter is
assigned an Interrupt Number which is already used
by another device adapter. In such a case, the conflict
of Interrupt Number will cause faults in the behavior of
both devices. Then it is necessary to run the CMOS
Setup utility, and manually assign a non-conflict
Interrupt Number.
E-5