- 14 -
IR LED
32pcs, 850nm IR LED
Memory
SD Card (4GB – 32GB)
SD Card cycle
ON/OF
Time Lapse
Yes
Ambient Sensor
Light, Temperature
Shooting Numbers
1-5, 1 pic per 1 second
Wireless
Wi-Fi AP, 2.4 GHz
Trigger Time
0.4-0.5S
Recovery Time
1.5-3S
Microphone
Waterproof microphone with small pin hole pointed at ground
USB 2.0
On the bottom of the camera
Operation Power
Battery: 12V; DC: 12V
Battery Type
8 AA Alkaline/ NI-MH
Operating Temperature
-25°C to 60°C
Storage temperature
-30°C to 70°C
Operation Humidity
5%-90%
Waterproof spec
IP54
Certification
CE-RED FCC-ID RoHS
Specifications are subject to change without prior notice.
6. Trouble Shooting
6.1 Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm environmental
conditions, set the Sensor Level to “High” and for cold weather use, set the sensor for “Low”.
2. Try to set your camera up in an area where no heat resources are in the camera’s field of
view.
3. In some cases, set the camera near water will make the camera take images with no subject
in them. Try to aim the camera over ground.
4. Try to set camera on stable and immovable objects, i.e.: large trees.
5. At night, motion detector may detect beyond range of the IR illumination. Reduce
distance setting by adjusting sensor sensitivity.
6. Rising sun or sunset can trigger sensor. Camera must be reoriented.
7. If person/animal moves quickly, it may move out of the camera’s field of view before
photo is taken. Move camera further back or redirect camera.
6.2 Camera Stops Taking Images or Won’t Take Images
1. Please make sure that the SD card is not full. If the card is full, camera will stop taking
images. Or user can turn on Cycle Recording to avoid such problem.
2. Check batteries to make sure that alkaline, or NiMH AA batteries left power is enough for
camera to work.
3. Make sure that the camera power switch is in the “On” position and not in the “Off” or “Test”