have a door or window partly opened away from the cooler to create a ‘flow through’ effect.
On days of high humidity the cooling effect may be reduced as air entering the filter may already be saturated with moisture. On
days like this it may be better to switch the cooling feature OFF and operate the unit as a fan only.
Operation
1) Ensure that the reservoir cap on the underside of the unit is tight. Pour clean cold water into the water filter
area, observing the water level indicator in the bottom front panel
CAUTION:DO NOT SPILL OR ALLOW WATER TO COME IN CONTACT WITH THE CONTROL PANEL
Do not overfill past the indicator mark. If desired, place ice in the tank in the top of the unit
CAUTION:
•
Do not pour water into the ice tank
•
Do not allow the combined use of water and ice to overfill the water reservoir
•
This is a portable air cooler. When moving the unit do so with caution to not spill any water in the reservoir. The unit
should be moved slowly and in a sideways direction
•
Always keep the unit upright
2)Connect the unit to a power outlet of the same voltage and frequency as indicated on the rating plate
3)Turn the light ON by pressing the SPEED / ON button. The unit will start and then revert to the highest speed.
Further pressing of the SPEED / ON button will select the airflow speed required (See note on fan speed operation)
4)If you wish to turn the unit off at a pre-determined time depress the TIMER button. The unit can be set to turn
off at any time between 0.5 hour and 7.5 hours from ‘Turn On’ by pressing the TIMER button. If no time is
selected, the unit will operate continuously. The time set can be incremented in 0.5 hour steps and the selected
time is indicated by a combination of indicator lights. Eg. 5.5 hours is indicated by the 4 hour LED, the 1 hour LED
and the 0.5 hour LED being illuminated.
5)To initiate the cooling function press the COOL button. It will take approximately 3 minutes for the air to cool.
NOTE:
If this button is not pressed the unit will only circulate ‘room temperature’ air
6)Move the horizontal louvers of the air outlet up or down to suit
7)The vertical louvers can be set to a direction or allowed to rotate through 120 degrees by pressing the SWING
button
8)All the functions can be performed with the remote control supplied with the unit
9)Press the OFF button to cancel all functions
10)When not in use disconnect the unit from the power outlet and drain ALL water from the water reservoir
11)Function Control
Fan speed control
When switched on, the fan motor operates at its highest speed (H). Pressing the SPEED button once, the speed will drop to
medium (M) and if pressed again the speed will drop to low (L)
Sleep
If the speed button is pressed three times after initial switch on the unit will operate at high speed (H) and the Sleep indicator
will illuminate. If the (H) Sleep cycle is selected the unit will operate at high speed for 0.5 hours, then reduce to medium (M) for
0.5 hours when it will switch to low (L) and continue to operate at this speed unit either the Timer switches the unit off or it is
switched off manually.
Pressing the Speed button 4 times after switch on will cause the unit to operate for 0.5 hours at Medium (M) sleep speed before
switching to low (L) and continue to operate as above.
