Logosol SH410, User Manual

Page: 5 / 32

5
LOGOSOL SH410
SAFE DISTANCES
No-one other than the operator is to be
present within 3 metres of the sides of the
machine or 6 m from the out-feed side when
in operation. There is to be a wall or other
barrier on the in-feed side, which stops any
thrown-out materials. The wall or barrier is to
be maximum 8m from the machine, but ide-
ally closer if short work pieces are processed.
Set up a form of cordoning which prevents
persons unintentionally entering the risk area
between the machine and the barrier on the
in-feed side.
Keep the workplace clean and tidy. Do not place
anything on the ground which you can later trip
over.
Never place your hands or any tools on the planing
table when the machine is running.
Do not climb onto the machine.
Do not tread on the machine's electric cable.
Make sure that the machine is positioned in such
a way that access to the emergency stop is not
blocked.
For greatest electrical safety, use a residual current
device .
The machine is not to be modified and is not to be
added to. Only use original parts supplied by Logosol
which are designed for the purpose.
After service,
the machine should be in its original condition.
The machine's warning markings are there for your
own and other's safety. Damaged or illegible labels
are to be replaced.
Blunt circular sawblades or knives increase the risk of
accidents.
WARNING! Risk of rebound.
The minimum permitted workpiece length:
300 mm. Make sure that you are familiar with
all functions and settings options before you
begin using the machine.
External environment: The motors and the electri-
cal system can be damaged if the machine is stored
or is used at temperatures below zero degrees C
or if it is stored in damp unheated environments.
Water can condense and collect in the motors and
the electrical system's housing, i.e. the control panel
(this applies to most sealed motors). There is a drain
plug on each motor which can be removed to check
that the motor is dry inside. Also check that water
has not collected in the control panel. This check
should be carried out regularly where there is a risk
of condensation.
Operator working area
Barrier behind in-
feed side
Cordoning
SH410 with in-feed and
out-feed table
Risk
area
WARNING!
The circular sawblade has only
two positions on the blade shaft. The locking
screw is to always be fully tightened in one of
the shaft's two countersinks.
WARNING! The circular sawblade is to only
be used on workpieces of thicknesses of less
than 77 mm.