logitrans WSP 2200, User Manual

Page: 10 / 24

6.
Power Supply
6.1 Accumulator supply
Scale on the handpallet KPZ is delivered with the charger. Delivered charger supply the
energy to built-in accumulator.
Charging: Protect the handpallet from moving. When the display is turned off you may
proceed and connect the charger to on-site power supply (230V), other end plug in to
the socket located in the front of the device.
When the charger cable is unplugged, the diode is showing CHARGE.
Green – accumulator charge up to 75%
Red – charging is still in process
After completing the charging process then automatically turn into safe mode. For full
charging effect, it should be preceded for 18 hours. Charger must be disconnected
before activating the handpallet.
Charger:
Always use original KPZ charging device. The use of any other device may cause
considerable damage to the electronics.
Charger should be checked before using for any damages. If the charging device is
damaged by accident or if any other defect exists, please check the output. If the output
is affected in any way, immediately order a new KPZ charging device. Any damage to
the charging device/power pack may result in a reduction or failure of the unit, resulting
in most cases damage to the scale.
Accumulator:
It is recommended to charge the accumulator every day over night. This way will be
guaranteed correct charge level indicator through the day. Charging system with limited
voltage strain protects from overcharging the accumulator. Low voltage strain
information appears on the display. Accumulator must be charged straight away. If
charging level is to low, scale is switching it self automatically off or it is impossible to
switch it back on.
The charge jack is at the front below the indicator on the right side.
From left side next to safety catch is located switch button to switch on and switch off
the display and the printer if it is installed.
.
10