20
7.0 Fault location key
7.1 Remedy
1) Check that the key (1) is turned clockwise and that emergency stop (2) is not
activivated.
2) Charge battery - (see separate instruction manual for battery and charger).
Access to the battery is achieved by removing the battery lid (3).
3) Check switch (4). Check cable connections on switch.
4) Check control current fuse (6).
If the fuse is intact and the truck does not drive, contact the dealer.
5) Check main fuse for driving motor (7).
Check cable connections on drive motor and pump motor.
If no fault can be found and the truck does not drive, contact the dealer.
6) Check the wire connections between the battery cells, and to the battery. In case of
verdigris on the connections, these are to be cleaned.
Check that all cable connections are fixed.
7) Check the wiring loom on the side of the wheel motor. Check that the brake is
activated when the handle is activated. Check that the brake is adjusted correctly.
If no fault can be found and the truck still brakes, please contact the dealer.
8) Please contact the dealer for the adjustment of the controller parameters.
9) Fill in oil through filler (8). The oil level must reach the underside of the filling plug.
Oil type:
Hydraulic oil ISO VG 15 (factory-filled with Texaco Rando HD 15).
Max. load given on name plate. If the truck can not lift the load, given on
the name plate, contact the dealer.
10) Check the fuse for the pump motor (9).
If the fuse is intact and the truck does not lift, contact the dealer.
11) Locate the oil leak and contact the dealer.
To localise the leak it is necessary to remove the rear cover (5).
12) Check the fuse for the charger (10).
13) Place the handle in drive position before turning the forward/reverse knob.
