14
11.
A REF
– Set the reference (minimum) scaled frequency value for the analogue output.
[Default 0]
Enter the displayed (scaled) value, below which the analogue output will be at the
minimum for the selected voltage/current range.
Press select
←
to select digit and increment
↑
to change value.
In signed mode, after cycling through all six digits, all digits will flash and the sign can
be toggled by pressing increment
↑
.
The number of decimal places is limited by the DISP DP setting.
Press settings
at any time to move to the next setting.
12.
A FULL
–
Set the full scale (maximum) value for the analogue output. [Default 0]
Enter the displayed (scaled) value, above which the analogue output will be at the
maximum for the selected voltage/current range.
Press select
←
to select digit and increment
↑
to change value.
In signed mode, after cycling through all six digits, all digits will flash and the sign can
be toggled by pressing increment
↑
.
The number of decimal places is limited by the DISP DP setting.
Press settings
at any time to move to the next setting.
13.
D OUT
– Set the digital frequency divider factor. [Default 0]
This can be set anywhere between 0 (digital output off) and 1 (digital output
frequency equal to the input frequency). Values greater than 1 will be set to 1
automatically.
Press select
←
to select digit and increment
↑
to change value.
After cycling through all digits the decimal point position can be altered by pressing
increment
↑
.
Press settings
at any time to move to the next setting.
14.
WAIT
– Set the wait time in seconds [Default 1]
Set the wait time in seconds that the unit will wait to receive a pulse on the active
input(s) before displaying zero (or the offset value if this has been set).
This setting can be anywhere between 0 and 20.
Press increment
↑
to change value.
Press settings
or select
←
to move to the next setting.