Quick Installation Guide
LPIX15-01-S-ABF
Connect the power cable
When LPoE feature cannot be utilized, a 12V DC external power supply is
necessary for the camera. Install ferrules for the copper wires of the power
supply. Use a crimping tool to perform this process. Connect the 2×0.5 mm
2
copper wire to the two-pin power connector of the camera (
GND
and
+12V
phase). The PCB terminal block can be found at the back of the camera. Use a
screwdriver to push in the orange colored plastic spring lifter, connect the
wires then release the spring lifter!
The LED states
•
The rear view draw shows the location of the camera LEDs.
LED1
LED2
Indicating
Network Link – Activity
Power – Ready
State1
Blinking in green
according to Ethernet
communication
Lights up in green if the
camera gets power
State2
Blinking in green and red
if the camera is ready to
use
Connecting the I/O ports
2 programmable Input/Output ports (NO, NC / OC 0.5A/30V) are available in
the camera. Connect the external I/O devices to the appropriate pins (
I/O-1
and
I/O-2
)! The PCB terminal block can be found at the back of the camera.
Use a screwdriver to push in the orange colored plastic spring lifter, connect
the wires then release the spring lifter!
Connect Audio Input
The spring connector of the Audio Input can be found at the back of the
camera marked as
MIC
. Use a screwdriver to push in the orange colored plastic
spring lifter, connect the wire then release the spring lifter!
2/3
