32
GB
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect
the unit from the mains supply.
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher baskets, load the dishes and push the baskets back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not slam the
door.
5. Press the
button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the section
Wash Cycle Table.
7. The indicator light of the selected programme will illuminate.
8. Press the
button, the washing cycle will begin shortly.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has dispensed
the detergent or detergent tablet. This will depend on how long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press the
button to pause the washing. Then press and hold P
until the unit becomes standby state. Press P again to select the new programme and confirm the selection by
pressing the
button. The unit will start the new washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
Switching Off the Unit
To save energy, remember to switch the dishwasher off using the button. The dishwasher will continue to use
electricity unless it is switched off with the button.
If you open the dishwasher’s door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip more easily when
they are hot. Therefore, if you open the dishwasher door fully after switching off, it will allow the dishes to cool
down much faster.
LDWTT15E_IB_5L_Final150424.indb 32
24/4/15 7:31 pm
