GB
3. Connect the angled end of the white
headed hose to the water inlet valve on the
machine. Hand tighten the plastic parts of the
connections. If you are unsure, please call a
qualified plumber for safer connections.
4. Open the tap slowly and check that there are
no leaks around the connection joints.
2. Fit the straight end of the water supply hose
to the cold water tap.
Connecting the Water Supply Hose
1. To prevent leakage from the connection joints,
ensure the rubber washer seals are fitted to
each end of the water supply hose. Do not use
without the seals in place.
Water Drain Hose
Points to remember:
• Don’t twist, pull out or bend the drain hose.
• Your washing machine should be no more than 85 cm from the drain outlet.
• The water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from
the ground.
Draining to a sink or wash-basin
• Secure the drain hose in position, so it can’t drop out of the basin.
• Don’t block the basin’s drain outlet, and make sure that the drainage through it is sufficient to
prevent overflowing.
• Don’t let the tip of the drain hose dip into the drained water, as this can cause the water to flow
back into the washing machine.
U-Shape Holder
(not included)
Draining to a wash-basin
Draining to a drain hose
* All images are for indication only; please refer to your individual unit for actual item.
3/4”
3/4”
min. 10 mm
min. 10 mm
Plastic joint
Rubber washer
INSTALLATION
32
L714WM12E_IB_7L_130529_Shaun.indb 32
29/05/2013 7:31 PM
