Thank you
for purchasing your new Logik Blender.
We recommend that you spend some time reading this instruction manual in
order to fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this instruction
manual for future reference.
GB-4
GB-5
DSG Retail Ltd. (Registered in England no. 504877)
Maylands Avenue, Hemel Hempstead, Hertfordshine, HP2 7TG, UK
Visit Partmaster.co.uk today for the easiest way to buy
electrical spares and accessories. With over 1 million
spares and accessories available we can deliver direct
to your door the very next day. Visit www.partmaster.co.uk or call 0844 800 3456 (UK
customers only) Calls charged at National Rate.
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the end of its
life separately from your household waste. There are separate collection
systems for recycling in the EU. For more information, please contact the
local authority or your retailer where you purchased the product.
QSG-L15BSS13-130131V1
Instruction Manual
Blender
L15BSS13
OPERATION
1. Make sure the jug and the lid are secure and in the Locked position.
2. Turn the Speed Dial to ‘0’.
3. Plug your blender into the mains socket and switch on the power.
Do not run the appliance continuously for more than 3 minutes.
After a full 3 minute cycle allow the blender to rest for another 5
minutes before using it again.
Operation
• Select the desired operating speed. There are 2
speeds. Move the Speed Dial progressively to the
right to increase the speed. When you start
blending use a low speed to begin and gradually
increase the speed if necessary.
• To stop, turn the Speed Dial back to ‘0’.
Use this mode when ingredients need to be
blended in small repeated bursts.
• Turn the Speed Dial to ‘P’ and hold it there for a
short time.
• To stop the operation, release the Speed Dial will
automatically return to ‘0’.
Continuous (Normal)
Pulse
AFTER USE
After you have finished blending:
1. Set the Speed Dial to ‘0’.
2. Hold the jug by the handle and carefully turn it clockwise (towards you) to
release the jug. (This may be easier with one hand on the base and one hand
holding the jug handle).
3. To pour out the contents, rotate the lid of the jug anticlockwise to free it and
then lift off the lid. Pour or spoon the contents out carefully.
4. Unplug the blender from the mains socket.
• Do not run the appliance continuously for more than 3 minutes.
After a full 3 minute cycle allow the blender to rest for another 5
minutes before using it again.
• Never blend very hot liquids in the blender. This is dangerous as
the contents may erupt.
• If you spill liquid on the blender base immediately switch off and
wipe dry.
During blending, you can feed in small amounts of food or liquid through the
jug lid. To do this:
1. Hold the lid.
2. Turn the stopper slowly anti-clockwise to free it and then lift it out.
3. Gradually feed pieces of food or liquids into the jug through the feeder.
4. Fit the stopper back when you have finished.
CLEANING
Cleaning the blender jug:
1. Pour about 500ml of warm soapy water into the jug and place the jug on the
base.
2. Turn and hold the Speed Dial to ‘P’ for a few seconds to loosen any food
particles and free them from the blades.
• Remove the jug, pour away the water and rinse in fresh running water.
Repeat 1 and 2 with fresh water.
• Alternatively the jug may be immersed in warm soapy water and cleaned
using a long handled brush. Do not touch the blades when cleaning.
• Wash the lid and stopper separately in warm soapy water, rinse and allow to
dry.
• DO NOT wash the jug or attachments in a dishwasher.
Cleaning the base:
• Ensure the blender is switched off and unplugged from the mains.
• Wipe the outer surface of the motor unit with a damp cloth. Never use abrasive
cleaners or scouring creams.
Always operate blender with cover in place.
The jug body should be handled carefully. The jug contains moving
parts - do not leave the jug immersed in water for any longer than
necessary to clean it or you may affect the operating performance of
the blender.
STORAGE
After all the components have been washed and dried, re-assemble the blender and
store it out of direct sunlight and out of the reach of children.
The cable may be wound around the lugs at the bottom of the appliance for easier
storage.
SPECIFICATIONS
Power :
230V~50Hz, 450W
Capacity of Jug : 1.5 litres max.
Duty Cycle :
3 minutes ON; 5 minutes OFF
We continually strive to improve our products, specifications may change without
prior notice.
C
M
Y
CM
MY
CY
CMY
K
L15BSS13_IB_final_130131.pdf 1 31/01/2013 5:45 PM
