LogicPower LPT-1000RD, User Manual

Page: 12 / 20

10 W W W . L O G I C P O W E R . U A
SAFETY INSTRUCTIONS
·
Do not open or disassemble the device. Do not make changes to the
scheme.
·
It is not allowed to connect a device of higher power than indicated on the
packaging of the device.
·
Do not operate the device with mechanical damage of the housing and/or
power cable, if there are elements that move freely inside the housing,
water or other liquids inside the housing, metal conducting parts
(including metal chips and dust), in the presence of contact with acetone,
gasoline and other chemically active, explosive and fire hazardous
substances.
· It is not recommended to connect electric heating and industrial devices
to the stabilizer.
· Do not use the stabilizer for industrial purposes.
·
When operating, the housing can become very hot, so it is necessary to
ensure good ventilation.
·
After the end of using the device, it is recommended to disconnect it from
the power grid.
ELEMENT LAYOUT
POWERING UP. OPERATING PROCEDURE
To turn on the product, you must connect it to the 220V power grid and set the switch
to the “ON” position. An information display should turn on
. Then the device starts
circuit testing process - for a few seconds display indicates “DELAY”. When the
testing ends, the device will
display the information about the input/output voltage.
Now you can connect the consumer devices to the sockets of the stabilizer, one at a
time.
Power
switch
Power
switch
Display
Display