Step-by-Step Installation Guide
Confirm Accessories in Kit
1
Waterproof pendant
Wrist Strap
(Shown with
waterproof pendant)
Lanyard
Test the Unit
3
Place call to Emergency Operator:
a. Push GRAY EMERGENCY button for 2 seconds on Pendant (RED LED
on the pendant should turn ON for 1 second)
b. You should hear a dial tone, dialing and then communication tones
between the CaretakerSentry and central station. Several seconds later
the operator should answer the call
c. Talk normally to the base unit – just like speaker phone
d. At the end of the conversation, the CaretakerAlert should automatically
hang-up – if not, push the CANCEL button for 1 second
Red Code Learn button
Teach the Pendant to the
System
2
On the Base Unit
a. PUSH and RELEASE the RED Code Learn button on
back of base unit. You will hear a voice prompt, “Pendant
Learning.”
On the Pendant
a. PUSH the GRAY Emergency button until you hear,
“Pendant Learning” from the base. Then, release the button
on the pendant.
i. If you hear, “Base and Pendant out of Range,”
STOP - wait 30 seconds and begin step 2 again.
b. When pendant learning has been successful, you
will hear, “Pendant Code Learned,” and then it will
announce the call setting that the base is set to -
Programming Mode or Emergency Call Mode.
Performing a System Test
a. PUSH and HOLD the CANCEL button for
8-10 seconds
to
enter
“System Check”
b. Push GRAY EMERGENCY button for
2 seconds
on Pendant
(RED LED on the pendant should turn ON for 1 second)
c. Listen for voice prompt from base unit:
i. “All Systems are OK – Battery is OK” is heard if the system is correctly installed
ii. If any other voice prompt is heard, the unit will describe the problem
d. Push and release the CANCEL button for 1 second to exit Test Mode
(unit will automatically exit in 3 minutes)
e. We recommend that you perform this System Test weekly
*NOTES:
Erasing all previously learned pendants
– hold down the (Red) Code Learn
button for 8 seconds. You will hear the confirmation of “Erasing All Pendants, All Pen-
dants Erased” from the base unit. Now you can re-teach pendants starting at Step #2.
Lost Pendants
– If a pendant has been lost, follow the note for “Erasing all
previously learned pendants” and then re-teach all of the pendants starting at Step #2.
Teaching additional pendants
- does not erase previously learned pendants.
Exiting Learning Mode
- Base will automatically exit the pendant learning mode
after successfully learning the pendant or after the base announces “Pendant Learning
Failed”.
Up to 9 waterproof pendants can be taught to each base.
