Logic DM800i, Instruction Manual

Page: 7 / 20

WIRING CONNECTION
To rear camera video out
To reverse gear control switch
To Hand brake switch
ANTENNA
CONNECTOR
FRONT
REAR
AUDIO OUT
CAMERA IN VIDEO IN
VIDEO OUT 1
VIDEO OUT 2
R
L
L R
L R
ISO CONNECTOR
B
A
1
2
3
4
5
6
7
8
4
5 7
8
REAR
OUT
CAMERA IN VIDEO IN
R
L
L R
To rear camera video out
To reverse gear control switch
To Hand brake switch
ANTENNA
CONNECTOR
FRONT
REAR
AUDIO OUT
CAMERA IN VIDEO IN
VIDEO OUT 1
VIDEO OUT 2
R
L
L R
L R
ISO CONNECTOR
B
A
1
2
3
4
5
6
7
8
4
5 7
8
REAR
OUT
CAMERA IN VIDEO IN
R
L
L R
CONNECTOR A
4. 12V
5. AUTO ANTENNA OUTPUT
7. +12V (TO IGNITION KEY)
8. GROUND
NOTE: (connector A no. 7) must be connected by car ignition
key in order to avoid that car battery becomes weak when the
car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the
replacement, there may be an internal malfunction. In this case, consult your nearest repair center.
Warning
Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause serious damage.
B
1 3 5 7
2 4 6 8
5 7
4 8
A
DRIVING WITH VIDEO DISPLAY
Follow the instructions below so video will display even when the vehicle is in motion.
Note: Always follow local laws regarding driving with video.
INSTALLING REAR CAMERA FOR REVERSE MOTION
Follow the instructions below to have the unit automatically switch to a read camera (not included) to
guide the driver when parking or moving in reverse.
Steps: Connect the GRAY wire to the WHITe wire.
Steps:
1. Connect the Rear Camera IN plug to the rear camera’s
video out plug.
2. Connect the ReD wire to “ReVeRSe” gear control switch.
3. Check your gear control switch and make sure it is
connected to +12V.