15
5.3
SELECT COMMAND SET
A software utility can be used to select one of the command sets when LCIGP is
downloaded in flash ROM. This is default firmware downloaded in the pole display.
Run the software utility.
Command set options are as follows:
LCI
– Logic Controls command set with OPOS command codes
AEDEX
– Aedex command emulation
NORITAKI
– Noritaki command emulation
LCI3400
– Logic Controls PDX3400 model command emulation
UTC1100(SD)
– Ultimate1100 command emulation with initial stand mode
UTC1100(EN)
– Ultimate1100 command emulation with initial enhanced mode
UTC220XLT
– Ultimate220XLT command emulation
EPSON110-D202
– Epson 110-D202 command emulation
1. Select the port name and the baud rate
in the “Communication Port” group
box. The baud rate must match the baud rate data shown on the pole display.
2. Select the command set.
3. C
lick “Save to Pole Display” to save the command into the display.
Then the pole display will be reset automatically, and show the new command set
saved.
